|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
July 7th 04, 02:58 AM
|
|||
|
|||
Saving settings when changing batteries
I've noticed that when I change batteries in my digicam all
the settings revert back to defaults. Perhaps this can be avoided by plugging the camera into an AC adapter before pulling the batteries? Has anyone tried this? 
|
|
#2
July 7th 04, 04:11 AM
|
|||
|
|||
|
Saving settings when changing batteries
Digicams have differing ways of dealing with this....let us know what cams
you are referring to so we can address that particular model. "Swingman" wrote in message ... I've noticed that when I change batteries in my digicam all the settings revert back to defaults. Perhaps this can be avoided by plugging the camera into an AC adapter before pulling the batteries? Has anyone tried this?
|
|
#3
July 7th 04, 03:17 PM
|
|||
|
|||
|
Saving settings when changing batteries
I have a FinePix S3000.
"Gene Palmiter" wrote in message = ... Digicams have differing ways of dealing with this....let us know what = cams you are referring to so we can address that particular model. =20 =20 "Swingman" wrote in message ... I've noticed that when I change batteries in my digicam all the settings revert back to defaults. Perhaps this can be avoided by plugging the camera into an AC adapter before pulling the batteries? Has anyone tried this? =20
|
|
#4
July 7th 04, 06:23 PM
|
|||
|
|||
|
Saving settings when changing batteries
"Swingman" wrote in message ... I've noticed that when I change batteries in my digicam all the settings revert back to defaults. Perhaps this can be avoided by plugging the camera into an AC adapter before pulling the batteries? Has anyone tried this? If you put the new batteries in within a few minutes, the settings should not be lost.
|
|
#5
July 7th 04, 06:23 PM
|
|||
|
|||
|
Saving settings when changing batteries
"Swingman" wrote in message ... I've noticed that when I change batteries in my digicam all the settings revert back to defaults. Perhaps this can be avoided by plugging the camera into an AC adapter before pulling the batteries? Has anyone tried this? If you put the new batteries in within a few minutes, the settings should not be lost.
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Tired of AA sized batteries | Bert Hyman | Digital Photography | 48 | July 5th 04 02:24 PM |
| Kodak CX6200 vs. Old NiMH batteries | Roger Stone | Digital Photography | 6 | June 28th 04 03:39 PM |
| NiMh batteries drain too quickly | Giorgio Preddio | Digital Photography | 7 | June 28th 04 09:49 AM |
| NiMh batteries drain too quickly | Giorgio Preddio | 35mm Photo Equipment | 7 | June 28th 04 09:49 AM |
| JPEG Questions: Loss In Quality When "Saving" | Xtx99 | General Photography Techniques | 3 | April 8th 04 04:25 PM |
Linear Mode
