If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Slave Flash with Panasonic FZ5
I purchased a Metz 28 CS-2 for use with the FZ5. Does anyone know if
the FZ5 uses a preflash. I'm not talking about the preflash for red eye reduction. I'm talking about a measuring (focus) preflash. The flash unit can compensate for it, but in my tests, the exposure seems to be identical with the built in flash and the slave unit, so I think the slave is going off either before or after the shutter. |
#2
|
|||
|
|||
"HarveyB" wrote in message oups.com... I purchased a Metz 28 CS-2 for use with the FZ5. Does anyone know if the FZ5 uses a preflash. I'm not talking about the preflash for red eye reduction. I'm talking about a measuring (focus) preflash. The flash unit can compensate for it, but in my tests, the exposure seems to be identical with the built in flash and the slave unit, so I think the slave is going off either before or after the shutter. This unit from Metz has a self learning slave mode. You can set it so that it ignores the test flash. This test flash occurs so close to the main flash that the human eye has difficulty in detecting it, but it remains quite obvious to the Metz unit. The unit can even measure multiple test flashes and be set to ignore them all and to fire with the main flash. I use exactly this unit with the FZ10 and it works fine, but my other (dumb) slave units don't. I have no idea if the FZ5 has a preflash or not, but I suspect that it does. Robert |
#3
|
|||
|
|||
I already know about the self learning feature and had set the flash
with that, but the results with or without the slave were identical. Then it occurred to me that they might be identical because the distance was well within the range of the built in camera flash. I increased the sensitivity of the slave to see if I would get an overexposed picture. This would tell me if it was actually working. Eureka! Thanks for your input. I love this little jewel. |
#4
|
|||
|
|||
"HarveyB" wrote in message oups.com... I already know about the self learning feature and had set the flash with that, but the results with or without the slave were identical. Then it occurred to me that they might be identical because the distance was well within the range of the built in camera flash. I increased the sensitivity of the slave to see if I would get an overexposed picture. This would tell me if it was actually working. Eureka! Thanks for your input. I love this little jewel. Yes, it is really neat. I don't know how you are using it, but I use mine for providing side lighting by positioning it out of the picture and to one side of the subject. A small pice of paper taped over the cameras flash lets the side lighting become dominant - all very trial and error but can make for a good picture :-) And sometimes to light up the far end of a longish room or, for instance, to add lighting to the middle distance. I haven't yet worked out how far away the slave can be and still get actuated. Robert. |
#5
|
|||
|
|||
HarveyB wrote: I purchased a Metz 28 CS-2 for use with the FZ5. Does anyone know if the FZ5 uses a preflash. I'm not talking about the preflash for red eye reduction. I'm talking about a measuring (focus) preflash. The flash unit can compensate for it, but in my tests, the exposure seems to be identical with the built in flash and the slave unit, so I think the slave is going off either before or after the shutter. Harvey, The FZ5 uses an orange colored LED to assist with low light focusing. It may not be bright enough to trigger the slave flash. If it is a problem the LED can be turned off. The camera also uses a pre-flash for red eye reduction. This feature can also be turned off. TR |
#6
|
|||
|
|||
The organge colored LED does not set off the flash. I tried increasing
exposure on the flash and it washed out the picture, which means it is functioning properly. I love it. As far as the red eye problem, the flash can adjust for this. However, I never use the red eye feature, as I would rather deal with the red eye in Paint Shop Pro than put up with the shutter lag. Thanks to all for your suggestions. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Radio-controlled slave flash trigger | canongirly | Digital Photography | 0 | March 20th 05 11:09 AM |
Why does my camera not see the slave flash? | Henry Law | Digital Photography | 18 | March 5th 05 05:20 AM |
Slave Flash | Helge Buddenborg | Digital Photography | 12 | February 26th 05 06:22 PM |
Fill Flash with the Canon 20D? | Ryadia | Digital Photography | 14 | December 17th 04 09:46 PM |
Flash for EOS D-Reb. | Gisle Hannemyr | Digital Photography | 3 | June 25th 04 04:21 AM |