If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Custom 8x10 (or nx10) film holder
So far I've found no easy way to keep 8x10" film flat in the Epson scanner.
I'm struck with the idea of making a film holder that would have an expanding dimension, for example the short dimension (8") would slide ever so little, held in tension by a pair of mild springs in the holder. To keep the film in place, one could punch it (film register punches are available) so that it is held on pins built into the holder's edge. Silly idea? |
#2
|
|||
|
|||
Custom 8x10 (or nx10) film holder
I use a piece of clear glass on top of my 11x14 transparencies, and
under the transparency adapter, with my Epson 11x17 scanner. Jim 2 wrote: So far I've found no easy way to keep 8x10" film flat in the Epson scanner. I'm struck with the idea of making a film holder that would have an expanding dimension, for example the short dimension (8") would slide ever so little, held in tension by a pair of mild springs in the holder. To keep the film in place, one could punch it (film register punches are available) so that it is held on pins built into the holder's edge. Silly idea? |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Film Lover's Lament | Summer Wind | 35mm Photo Equipment | 102 | March 28th 06 03:15 PM |
Da Yi 6x17 back for 4x5 [Review] | Bandicoot | Large Format Photography Equipment | 8 | January 26th 05 01:04 AM |
Road ruts with Jobo | Brian Kosoff | In The Darkroom | 64 | January 27th 04 12:08 AM |
FS: 8x10 Polaroid film holder | Collin Brendemuehl | Large Format Equipment For Sale | 0 | October 30th 03 04:00 PM |
FS: Fidelity Elite and Other 8x10 Film Holders | BCE | Large Format Equipment For Sale | 0 | September 29th 03 11:16 PM |