If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Printing on the back of a print.
In article , Jean-David Beyer wrote:
Mark in Maine wrote: I want to make a calender, by printing the calender grid thing on the back of some RC prints, then spiral binding them together. I have been using Ilford RC paper, but am having a hard time finding something that will print on the back - if I use an inkjet (Epson 1280) - the ink does not seem to dry, and is very susecptible to water. I also have a laser printer, which is better, but I get a ghost image, about an inch away from the original image. Has anybody done this before - any comments, suggestions, etc? Mark Why not just print out your calendar pages on a separate sheet of laser paper, and then with spray glue, glue this to the back of the RC print? THen you can trim the edges to cut off any misaligned overhang. I do this all the time to make photo cards. |
Thread Tools | |
Display Modes | |
|
|