![]() |
If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
![]()
Hello,
I would like to know if the B&J Solar enlarger can be used to enlarge 5x7 negatives. Does anyone have experience with this enlarger? Curt Blood |
#2
|
|||
|
|||
![]()
On 03 Feb 2004 12:46:57 GMT, (CBlood59) wrote:
Hello, I would like to know if the B&J Solar enlarger can be used to enlarge 5x7 negatives. Does anyone have experience with this enlarger? Curt Blood If the diffusion plate is 5X7 then the enlarger can be used to enlarge 5X7 negatives. I'm no authority on enlargers but I think the Solar is a re-branded Elwood. Regards, John S. Douglas, Photographer - http://www.darkroompro.com Please remove the "_" when replying via email |
#3
|
|||
|
|||
![]() |
#4
|
|||
|
|||
![]()
On 03 Feb 2004 23:54:26 GMT, (JCPERE) wrote:
AFAIK Solar and Elwood had nothing to do with each other. Chuck You could well be right. For some reason I was under the impression that B&J bought their enlargers from Elwood. Regards, John S. Douglas, Photographer - http://www.darkroompro.com Please remove the "_" when replying via email |
#5
|
|||
|
|||
![]() "CBlood59" wrote in message ... Hello, I would like to know if the B&J Solar enlarger can be used to enlarge 5x7 negatives. Does anyone have experience with this enlarger? Curt Blood I have one sitting on the other side of the room. This is the diffusion model and will take 5x7. A similar chassis was used with a combination condenser/diffuser for 4x5. Mine takes the impossible to find No.301 enlarger lamp the same as some Elwood models. I had one the condenser enlargers many years ago. It used a PH 211 lamp. This will take one but I think the reflector is intended for the larger envelope of the 301. Solar was a trade name of Burke & James. These were good quality not very expensive enlargers. They are set up to take several kinds of lens boards including 4x5 Speed Graphic boards. You may have to shim the base to get it into alignment. -- --- Richard Knoppow Los Angeles, CA, USA |
#6
|
|||
|
|||
![]() |
#7
|
|||
|
|||
![]()
Thanks for the input.
Curt Blood |
Thread Tools | |
Display Modes | |
|
|