If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
FA: Two Older Bronica Items -- a Rear Lenscap and a Body Cap
I acquired these in a trade, and don't know which Bronica model they
fit. The body cap fits into an opening that's 66mm (or 2.6 inches) in diameter. The rear lenscap is a little over 56mm (or 2.2 inches) in diameter, and has three tabs which extend out slightly. It is about 46mm (or 1.8 inches) deep. Both are in good, usable condition but with lots of scuffs and scratches. On the other hand, if you need to protect a rear lens element, or to keep dust out of you camera body, these will work as good as new, and cost much less. http://cgi.ebay.com/ws/eBayISAPI.dll...m=330019124098 |
Thread Tools | |
Display Modes | |
|
|