If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Circ. pol dunked in sal****er. Cleaning?
On 10-01-21 20:34 , BobS wrote:
"Alan wrote in message ... On vacation I managed to drop a circ pol into the water. I recovered it about 20 minutes later (was under a dock and hard to access). It is the Minolta circular polarizer from the 90's. (72mm). I immediately rinsed it off and let it dry, expecting there to have been water seepage into the pol between the two elements. Yesterday I took the polarizer apart, to a degree. The outer ring and the inner pressure ring segment came off with no problem, but I can't separate the two elements. I also suspect that NO WATER entered between the two elements at all. I certainly can't see any "stain" or anything in there... Anyone with advice on what (not) to do? I'm leaning to cleaning the accessible surfaces and not attempting to separate the elements. Alan, Some CP's are made from 2 pieces of glass with the polarizing film sandwiched between them. Do not try to separate the two halves or you will ruin the polarizer. Ah. That explains what somebody replied on another forum. Thanks. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Circ. pol dunked in saltwater. Cleaning? | Alan Browne | Digital SLR Cameras | 30 | January 29th 10 02:05 PM |
Circ. pol dunked in saltwater. Cleaning? | Ofnuts | 35mm Photo Equipment | 2 | January 22nd 10 02:31 PM |
Maybe silly question - Circ Polrz Filters | TheNewsGuy(Mike) | Digital Photography | 2 | April 27th 06 01:40 PM |
FS: Tiffen 77mm Circ Polarizer, LN | Donald Specker | General Equipment For Sale | 0 | October 9th 05 04:01 PM |
S50 dropped in saltwater | Azzz1588 | Digital Photography | 2 | August 8th 04 03:22 PM |