If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Hanimex Rondette projector jamming
Hello there,
I recently bought a Rondette 1500 EF at a flea market. When first switched on it works fine, fan comes on , autofocus works and the magazine advances and reverses. However, as it "warms up", the advance mechnism begins to jam. When the advance button is pressed the slide changing arm moves out and sticks, but the magazine doesn't move. Operating the reversing button makes the slide changing arm go in again, but the cog that moves the magazine stays still. I would be grateful if anyone could help me on this. Might it be an electrical fault on the small controlling circuit? I've taken the projector apart and can't see anything obviuosly wrong mechanicaly. After reassembly it works fine again, until it warms up. Thanks everyone |
Thread Tools | |
Display Modes | |
|
|