If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
Previously, a few months ago, I requested advise here about Oceanside Camera Repair done by Harry Fleenor ... he did GREAT work. Everything is super smooth and sharply accurate. He told me it takes a_half_a_day to do the job of a shutter overhaul, for $134? That is normally about a two hour charge for work, so, a great deal IMO. And these medium format cameras have much more resolution than any pos P/S digital cams with much greater detail, and film is still more artistically beautiful, and can be scanned on a decent flatbed with a light lid. THANKS all for the good advise! -- Giant_Alex })))* not my site: http://www.e-sword.net/ |
#2
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
On 2007-11-23 09:41:57 -0500, "AAvK" said:
Previously, a few months ago, I requested advise here about Oceanside Camera Repair done by Harry Fleenor ... he did GREAT work. Everything is super smooth and sharply accurate. He told me it takes a_half_a_day to do the job of a shutter overhaul, for $134? That is normally about a two hour charge for work, so, a great deal IMO. And these medium format cameras have much more resolution than any pos P/S digital cams with much greater detail, and film is still more artistically beautiful, and can be scanned on a decent flatbed with a light lid. THANKS all for the good advise! You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- Michael |
#3
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- Michael Yes, but that's about a $300 set of two jobs though. Do you think it's worth that much? Because you'd need a new 'Maxwell bright screen' installed which also entails readjusting the focusing mechanism (at cost), because the the new screen is thicker, it would have to be calibrated to "out further" from the film plane by the difference in thickness from your screen to the new one. It is an all inclusive job. Before I sent mine in, I did remove the whole finder and cleaned it all out myself, very carefully. You can do that too. And then, the shutter overhaul is it's own cost. I don't want to discourage you, but there are all these considerations, and there is about a 12 week turn around time before you get it back! Which model do you have, may I ask?????? -- Giant_Alex })))* not my site: http://www.e-sword.net/ |
#4
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- Michael This is the site: http://www.rolleirepairs.com/ AAvK |
#5
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
AAvK wrote:
You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- Michael Yes, but that's about a $300 set of two jobs though. Do you think it's worth that much? Because you'd need a new 'Maxwell bright screen' installed which also entails readjusting the focusing mechanism (at cost), because the the new screen is thicker, it would have to be calibrated to "out further" from the film plane by the difference in thickness from your screen to the new one. A ground glass focusing screen can be much improved in brightness and eveness by the simple addition of a drop-in plastic fresnel lens. No change in focus. They used to be available for Rolleis for less than $10...that would translate to less than $50 now. -- dadiOH ____________________________ dadiOH's dandies v3.06... ....a help file of info about MP3s, recording from LP/cassette and tips & tricks on this and that. Get it at http://mysite.verizon.net/xico |
#6
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
On 2007-11-23 17:25:34 -0500, "AAvK" said:
You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- Michael Yes, but that's about a $300 set of two jobs though. Do you think it's worth that much? Because you'd need a new 'Maxwell bright screen' installed which also entails readjusting the focusing mechanism (at cost), because the the new screen is thicker, it would have to be calibrated to "out further" from the film plane by the difference in thickness from your screen to the new one. It is an all inclusive job. Before I sent mine in, I did remove the whole finder and cleaned it all out myself, very carefully. You can do that too. And then, the shutter overhaul is it's own cost. I don't want to discourage you, but there are all these considerations, and there is about a 12 week turn around time before you get it back! Which model do you have, may I ask?????? I don't have the camera at hand right this minute. I researched it about seven or eight years ago and learned it was from 1956. I don't remember anything else about it. -- Michael |
#7
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
Hi AAvk,
Could you give me the co-ordinates for this person. I have a Rollei that is working fine, speeds are OK but I find everything about it sluggish, as if all the moving parts, levers, knobs, etc, needed lubrication; the camera seems to lack silkiness in its operation. You can send me the information off list! Cheers Michael wrote: On 2007-11-23 09:41:57 -0500, "AAvK" said: Previously, a few months ago, I requested advise here about Oceanside Camera Repair done by Harry Fleenor ... he did GREAT work. Everything is super smooth and sharply accurate. He told me it takes a_half_a_day to do the job of a shutter overhaul, for $134? That is normally about a two hour charge for work, so, a great deal IMO. And these medium format cameras have much more resolution than any pos P/S digital cams with much greater detail, and film is still more artistically beautiful, and can be scanned on a decent flatbed with a light lid. THANKS all for the good advise! You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- __________________________________________________ ______________ Bogdan Karasek Montréal, Québec Canada www.bogdanphoto.com "I bear witness" __________________________________________________ ______________ |
#8
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
What is 11-19-07? Bogdan Karasek wrote: Hi AAvk, Could you give me the co-ordinates for this person. I have a Rollei that is working fine, speeds are OK but I find everything about it sluggish, as if all the moving parts, levers, knobs, etc, needed lubrication; the camera seems to lack silkiness in its operation. You can send me the information off list! Cheers Michael wrote: On 2007-11-23 09:41:57 -0500, "AAvK" said: Previously, a few months ago, I requested advise here about Oceanside Camera Repair done by Harry Fleenor ... he did GREAT work. Everything is super smooth and sharply accurate. He told me it takes a_half_a_day to do the job of a shutter overhaul, for $134? That is normally about a two hour charge for work, so, a great deal IMO. And these medium format cameras have much more resolution than any pos P/S digital cams with much greater detail, and film is still more artistically beautiful, and can be scanned on a decent flatbed with a light lid. THANKS all for the good advise! You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- -- r.p.e.35mm user resource: http://www.aliasimages.com/rpe35mmur.htm -- r.p.d.slr-systems: http://www.aliasimages.com/rpdslrsysur.htm -- [SI] gallery & rulz: http://www.pbase.com/shootin -- e-meil: Remove FreeLunch. |
#9
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
Alan Browne wrote, on 11-29-07:
What is 11-19-07? A calendar date. |
#10
|
|||
|
|||
Rolleicord Va - I got it back 11-19-07
November 19, 2007
Bogdan Alan Browne wrote: What is 11-19-07? Bogdan Karasek wrote: Hi AAvk, Could you give me the co-ordinates for this person. I have a Rollei that is working fine, speeds are OK but I find everything about it sluggish, as if all the moving parts, levers, knobs, etc, needed lubrication; the camera seems to lack silkiness in its operation. You can send me the information off list! Cheers Michael wrote: On 2007-11-23 09:41:57 -0500, "AAvK" said: Previously, a few months ago, I requested advise here about Oceanside Camera Repair done by Harry Fleenor ... he did GREAT work. Everything is super smooth and sharply accurate. He told me it takes a_half_a_day to do the job of a shutter overhaul, for $134? That is normally about a two hour charge for work, so, a great deal IMO. And these medium format cameras have much more resolution than any pos P/S digital cams with much greater detail, and film is still more artistically beautiful, and can be scanned on a decent flatbed with a light lid. THANKS all for the good advise! You've got me ready to send him my old Rolleicord. It works, but the screen is dark and the shutter needs calibration. -- __________________________________________________ ______________ Bogdan Karasek Montréal, Québec Canada www.bogdanphoto.com "I bear witness" __________________________________________________ ______________ |
|
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Rolleicord newbie | Michael Keogh via PhotoKB.com | Medium Format Photography Equipment | 5 | February 6th 05 10:32 PM |
Rolleicord Vb | Alexz | Medium Format Photography Equipment | 7 | April 6th 04 03:52 PM |
rolleicord for sale | Andy wilson | General Equipment For Sale | 0 | December 30th 03 04:32 PM |
value on 1960's rolleicord vb | Andy wilson | General Equipment For Sale | 2 | December 29th 03 03:42 PM |
value on rolleicord vb | Andy wilson | Medium Format Equipment For Sale | 0 | December 27th 03 03:14 PM |