If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
fill flash with Nikon FE2 and Metz 45-ct4
Although I have never tried this, I think it is the way to go: with your
flash off or disconnected, meter your scene as usual. Note the exposure and set your camera and lens to this setting in the manual exposure mode. Then, turn on your flash, set the exposure compensation dial to the desired under-exposure. This should turn the flash off sooner, resulting in the fill-flash that you aiming for. Hope this helps. If I am wrong, please let me know! "A. Bharucha" wrote in message ... All, I have an FE2 with Metz 45-CT4 with SCA343 module. Is it possible to do fill-in flash in TTL. I want -1 or -2 fill in. There is no control on the camera specifically for limiting flash output for TTL. Can one adjust the exposure componsation by -2 and increase the film speed by 2 stops to get -2 fill in? What controls the amount of light the flash puts out...the ASA setting or the exp componsation or both? thanx. anil bharucha |
Thread Tools | |
Display Modes | |
|
|