If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#11
|
|||
|
|||
Toe speed of TMAX 400 (was fridge and heat problems)
Be careful when comparing manufacturer's curves. A visual glance at the
chart can give misimpressions. You have to plot each film using the same X,Y metrics. Further, you do not know what kind of light was used. And finally, some charts go off the scale of usable density. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
fridge and heat problems | Edwin | In The Darkroom | 15 | July 7th 04 04:43 AM |