If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Photo paper for pinhole photography.
I am going to do some pinhole photography and I was wondering what the
equivalent film ISO is for Ilford Multigrade IV RC paper. Also, what (of the many) equations do you use for the optimal pinhole diameter? |
#2
|
|||
|
|||
Photo paper for pinhole photography.
I'm not so much a purist when it comes to pinhole diameters but used to make
my holes in aluminum foil with a #10 sewing machine needle pushed in about half way then "burnished" both sides of the hole with the back of a spoon. For ISO with this sort of pinhole at 4" on 4x5 film (slightly wide angle) start at ISO 1. Note that you can also use a 4x5 film holder for the back of your camera, I've even used a Polaroid sheet film back and I tell you it don't get any easier than that. Type 55 is nice since it yields both a positive and a negative. Note that the positive must look quite light to have optimum negative exposure. When black and white 126 film was available I made little pinhole cameras from the cartridges and used a coin to wind the film after applying my high tech capping shutter to my lens (I covered the pinhole with a piece of black tape). -- darkroommike ---------- "Jevin Sweval" wrote in message om... I am going to do some pinhole photography and I was wondering what the equivalent film ISO is for Ilford Multigrade IV RC paper. Also, what (of the many) equations do you use for the optimal pinhole diameter? |
#3
|
|||
|
|||
Making pinholes
On 2/20/2004 8:20 AM Mike King spake thus:
I'm not so much a purist when it comes to pinhole diameters but used to make my holes in aluminum foil with a #10 sewing machine needle pushed in about half way then "burnished" both sides of the hole with the back of a spoon. I've gotten really good results using someone's method whose web page I can no longer find; he instructed to use thin brass shim material (around ..001"-.003"), not foil, and to make the hole with a very sharp needle using a backing of hard wood to avoid dimpling the metal too much. Then you use fine sandpaper to carefully sand away the small tube left by the needle. I've gotten nearly perfect pinholes smaller than .010" this way (checked by using a microscope, they're practically perfectly round and yield very good images). -- It's fun to demonize the neo-cons and rejoice in their discomfiture, but don't make the mistake of thinking US foreign policy was set by Norman Podhoretz or William Kristol. They're the clowns capering about in front of the donkey and the elephant. The donkey says the UN should clean up after them, and the elephant now says the donkey may have a point. Somebody has come out with a dustpan and broom. - Alexander Cockburn, _CounterPunch_ (http://www.counterpunch.org), 9/17/03 |
Thread Tools | |
Display Modes | |
|
|