If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Custom Change-Over for Eiki 3580's? Help
Possibly the wrong group to post this, but I thought I'd start somewhere, If
you know of a better grp to post - pls advise. Looking for a way to do a change over on a pair of Eiki 3580's. I've only seen on once, so I know its possible. Any Projector mechanics / automations specialists out there who can help? I was thinking of wiring the main switch's in parallel to a set of relay's. These relays would interface to a timing circuit that read que's placed on the film. To read the que's, I thought I'd use a sm photo-sensor placed somewhere in the film-path. When the 1st que passed under the photo-sensor it would shut off the light on Prjtr-1, wait a second or so then turn off the motor. At the same time, Prjtr-2 motor would run and turn on its light. Do I need another que here? Would like to go seamless as possible Thanks, Aaron |
Thread Tools | |
Display Modes | |
|
|