HP5+ streak w/Pyro

I just developed the above roll of 120 in Pyro and fix w/ TF4 following the
recommendations in the book. I've been using Pyro for about 4 years now and
have had good results overall. I noticed a random pattern of streak towards
one edge of the film. It is similar to the pattern you get when you take a
wet brush and shake it towards the ground in one stroke. Under the loupe it
is tiny black spots nearly the entire length of the film approx 1/16th inch
wide. Is this left on from the wash process, perhaps? I washed in a 120
metal film tank w/ four small holes in the bottom for 30 mins. that I hadn't
used before. Any knowledge is appreciated- Lib

In article ,
"lib" wrote:

I just developed the above roll of 120 in Pyro and fix w/ TF4 following the
recommendations in the book. I've been using Pyro for about 4 years now and
have had good results overall. I noticed a random pattern of streak towards
one edge of the film. It is similar to the pattern you get when you take a
wet brush and shake it towards the ground in one stroke. Under the loupe it
is tiny black spots nearly the entire length of the film approx 1/16th inch
wide. Is this left on from the wash process, perhaps? I washed in a 120
metal film tank w/ four small holes in the bottom for 30 mins. that I hadn't
used before. Any knowledge is appreciated- Lib

Check the Metaborate, you either need to mix up a fresh batch or just
shake it vigorously prior to using,.....and mix in final diluted
solution well.

--
LF Website @ http://members.verizon.net/~gregoryblank

"To announce that there must be no criticism of the President,
or that we are to stand by the President, right or wrong,
is not only unpatriotic and servile, but is morally treasonable
to the American public."--Theodore Roosevelt, May 7, 1918