If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
WANTED: Omega D-2 Lens Cone and Lens disc 421-102 421-008
Hi -
Sorry to clutter this board, but: I need the 4 1/2" lens cone for the D-2, and the lens disc for 50mm mount. If the part numbers appear (they don't always) they are 421-102 and 421-008. I want these to use with the Componon-s 150mm lens. Appearance not important - I can refinish them if needed - they just need to be straight and light-tight. If you have either and/or both, please drop me an email at: (bushy_hare 'at' yahoo.com) Thanks! |
#2
|
|||
|
|||
http://www.classic-enlargers.com/
This cone is not a very common item used, Harry might be your only source, he has new ones that were custom made for him. Or do what I did and make an extension ring. I used the top to a can of spray paint, cut the top out and attached the lensboard to the cone with longer screws using the lid as a spacer. The lip on the can lid fit perfectly in the hole in the cone. Also worked great for making reductions with the 135mm lens on the same cone. You might also post to rec.photo.marketplace.darkroom and http://www.khbphotografix.com/omega/ -- darkroommike ---------- "happyheathen" wrote in message ... Hi - Sorry to clutter this board, but: I need the 4 1/2" lens cone for the D-2, and the lens disc for 50mm mount. If the part numbers appear (they don't always) they are 421-102 and 421-008. I want these to use with the Componon-s 150mm lens. Appearance not important - I can refinish them if needed - they just need to be straight and light-tight. If you have either and/or both, please drop me an email at: (bushy_hare 'at' yahoo.com) Thanks! |
#3
|
|||
|
|||
http://www.classic-enlargers.com/
This cone is not a very common item used, Harry might be your only source, he has new ones that were custom made for him. Or do what I did and make an extension ring. I used the top to a can of spray paint, cut the top out and attached the lensboard to the cone with longer screws using the lid as a spacer. The lip on the can lid fit perfectly in the hole in the cone. Also worked great for making reductions with the 135mm lens on the same cone. You might also post to rec.photo.marketplace.darkroom and http://www.khbphotografix.com/omega/ -- darkroommike ---------- "happyheathen" wrote in message ... Hi - Sorry to clutter this board, but: I need the 4 1/2" lens cone for the D-2, and the lens disc for 50mm mount. If the part numbers appear (they don't always) they are 421-102 and 421-008. I want these to use with the Componon-s 150mm lens. Appearance not important - I can refinish them if needed - they just need to be straight and light-tight. If you have either and/or both, please drop me an email at: (bushy_hare 'at' yahoo.com) Thanks! |
Thread Tools | |
Display Modes | |
|
|