|
| If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|||||||
|
|
Thread Tools | Display Modes |
|
#1
May 5th 05, 07:25 AM
|
|||
|
|||
Pano adapter in RB67?
Has anyone ever tried (or thought about trying) to shoehorn the 35mm
panoramic adapter made for the Mamiya 7 into an RB67 or RZ67 film back? Is this total insanity, or might it just work? I haven't seen an adapter close up, but I assume it somehow fits onto the axles that normally take the 120 film spools - these also exist in the RB/RZ 67 backs, and must have identical spacing etc. The only bit that might need re-design is the 24x65mm mask, but I wouldn't think that would be too hard. Any thoughts? -- Remove numeral in e-mail address to send e-mails. www.marshallarts.com.au 
|
| Thread Tools | |
| Display Modes | |
|
|
Similar Threads
|
||||
| Thread | Thread Starter | Forum | Replies | Last Post |
| Quantum Qflash DTTLi adapter now available. | [email protected] | Digital Photography | 1 | April 1st 05 10:04 PM |
| Alternative A/C adapter for HP Photosmart camera | David Turrell | Digital Photography | 8 | October 29th 04 01:07 PM |
| Canon A 40 to 80 AC adapter question - polarity. | Dave Martindale | Digital Photography | 4 | October 20th 04 04:13 AM |
| FS: P Adapter & Polaroid Back for Mamiya RB67 | HMeier9160 | General Equipment For Sale | 0 | June 26th 04 02:55 AM |
| FA: MAMIYA RB67 PRO S REVOLVING ADAPTER | Mike | Medium Format Equipment For Sale | 0 | November 7th 03 09:58 PM |
Linear Mode
