If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Any Zone VI Enlarger users out there?
I was wondering if anyone has had problems with the head in regards to
using the lift lever to raise the head. After pulling the lever all the way to raise the head, I have to phyisically push the head up further to slide a neg carrier in. This seems like a bad design flaw to me. I also use a Beseler and while it has its own quirks, putting the neg carrier in works flawlessly. I was wondering if anyone has come up with a homegrown solution to this problem. thanx dp |
#2
|
|||
|
|||
Any Zone VI Enlarger users out there?
I use both enlargers, too; but I don't have this problem. Are you sure that
you're pulling the lever _around_ and in front of the nut that locks the head up until you've inserted the carrier? Not doing this would produce the problem you describe. -Lew |
Thread Tools | |
Display Modes | |
|
|