If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Print Dryers for Flattening Prints
"Norman Worth" wrote
I use a motorized drum dryer for my FB prints, and they come out nicely flat. Unfortunately, in this dry climate, they don't stay that way. In a couple of months they wind up quite curled. Is there a back treatment which will counteract that curl? Is mat board the only answere? I partialy air dry then blotter dry using hydrophobic separators which alternate with A flute corrugated board. I think a twelve hour dry about minimum. In a few days I've a little curled print. Not at all wound up though. Blotter books should be banned. They give blottering a bad reputation. Go with corrugated, A flute is best. Dan |
Thread Tools | |
Display Modes | |
|
|