If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
Question on morning setup prints in Noritsu 1801
Hello all,
I have problem with morning setup prints in Noritsu 1801. All 3 prints have different color, they are not grey. I did data clear, and after this completely setup lab - light source registered, cut filter setup and filter setup - everything... But, anyway +1D print comes with big magenta color. -1D print coms with cyan color. ND prints comes really grey, and photos from films comes great, but anyway I feel not everything OK. If I print 3 prints from the same negative - -1D, ND, +1D, they comes with different colors.... Maybe I have to replace filters? Lamp is new, densitometer and scanner are adjusted, everything cleaned up.... If somebody can help me, please email me privately (I don't often read newsgroups) to - Mike. |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
QUESTION: DRY MOUNTING LARGE GLOSSY PRINTS | Michael Bonnycastle | In The Darkroom | 6 | April 2nd 04 04:00 PM |