If this is your first visit, be sure to check out the FAQ by clicking the link above. You may have to register before you can post: click the register link above to proceed. To start viewing messages, select the forum that you want to visit from the selection below. |
|
|
Thread Tools | Display Modes |
#1
|
|||
|
|||
HP5+ streak w/Pyro
I just developed the above roll of 120 in Pyro and fix w/ TF4 following the
recommendations in the book. I've been using Pyro for about 4 years now and have had good results overall. I noticed a random pattern of streak towards one edge of the film. It is similar to the pattern you get when you take a wet brush and shake it towards the ground in one stroke. Under the loupe it is tiny black spots nearly the entire length of the film approx 1/16th inch wide. Is this left on from the wash process, perhaps? I washed in a 120 metal film tank w/ four small holes in the bottom for 30 mins. that I hadn't used before. Any knowledge is appreciated- Lib |
#2
|
|||
|
|||
In article ,
"lib" wrote: I just developed the above roll of 120 in Pyro and fix w/ TF4 following the recommendations in the book. I've been using Pyro for about 4 years now and have had good results overall. I noticed a random pattern of streak towards one edge of the film. It is similar to the pattern you get when you take a wet brush and shake it towards the ground in one stroke. Under the loupe it is tiny black spots nearly the entire length of the film approx 1/16th inch wide. Is this left on from the wash process, perhaps? I washed in a 120 metal film tank w/ four small holes in the bottom for 30 mins. that I hadn't used before. Any knowledge is appreciated- Lib Check the Metaborate, you either need to mix up a fresh batch or just shake it vigorously prior to using,.....and mix in final diluted solution well. -- LF Website @ http://members.verizon.net/~gregoryblank "To announce that there must be no criticism of the President, or that we are to stand by the President, right or wrong, is not only unpatriotic and servile, but is morally treasonable to the American public."--Theodore Roosevelt, May 7, 1918 |
Thread Tools | |
Display Modes | |
|
|
Similar Threads | ||||
Thread | Thread Starter | Forum | Replies | Last Post |
Correct dev. w/Pyro? | lib | In The Darkroom | 1 | February 21st 04 05:23 PM |